Voltage(option): 220V ~50Hz , 110V~60Hz
Power: 250~280W (MAX)
Controling temperature: 30-99 degree centigrade adjustable
Time to target temperature: 30 seconds
Hot pad size: 31 x 22cm
How to use:
1. To preheat the metal shell part: temperature control knob to 60 degrees, will face up for about 2 minutes.
2. The positive external heating outer peripheral down for about 2 minutes, turn over with a crowbar or inserted into the outer gap test picks
3.To study whether the plastic surface is softened, according to the actual situation and then adjust the heating time or temperature. The rubber surface softening, the temperature control knob to the 0 Degree or power off the power, with the remaining temperature to the glue in the case to keep the softening state, dismantling.
1. Ipad 85-90 degrees first face up for 5 minutes, and then face down 2-3 minutes, in turn, try to soften the rubber, with a sled stick to try, when the demolition temperature to maintain 80 degrees of time can not be too long, After the demolition of good temperature control to 0 degrees
2. Phone screen demolition box, 85-95 degrees down to the screen heating 6-8 minutes, with a pry bar to try to soften the plastic, if softened, demolition of the screen to maintain the temperature of 80 degrees Po
3. After the demolition of the closed temperature control to 0 degrees, more difficult to remove the screen can be 85 degrees of temperature appropriate heating time and time, and so on to close down after the closure of the temperature to 0 degrees. All disassembles should be completed within 20 minutes